How to Measure for a Shower Door

A shower door that's even a few millimetres out won't seal or close properly, and an opened door can't be resold as new. Please take five minutes to measure carefully before you order. If you're unsure about anything, call us or ask in the shop before ordering.

The golden rules

  • Measure after tiling is finished. The space left between the finished tiles decides the door size, not the space before tiling and not the tray size.
  • Measure tile to tile in millimetres at the top, middle and bottom of the opening. Walls are rarely perfectly straight, so the three figures are often different.
  • Every measurement must be inside the door's fitting range. Each product page lists the range under "Fits openings (tile to tile)" in the specifications.
  • The size name is not the opening size. Most doors fit an opening up to their nominal size or a little smaller, never bigger. For example, an 800mm ETO door fits openings of 750–790mm, so it will not fit an opening of exactly 800mm.

How to measure

Recess (door between two walls)

Measure the width from tile to tile at the top, middle and bottom. Use the smallest and largest figures: both must be within the door's fitting range.

Corner entry and side panel enclosures

Measure along each wall, from the finished tile to the outer edge of the tray (or the planned glass line on a wet room floor). Check each wall against its own fitting range: the door against the door range and the side panel against the side panel range.

Quadrant and offset quadrant enclosures

Measure both walls from the finished tile to the outer edge of the tray. The tray's curve must match the enclosure's radius, so check the radius in the product specifications before ordering.

Before you order a premium door

For our premium enclosures, including the Flair ETO and ILI ranges, the wall profiles only allow a small amount of adjustment. Please:

  1. Ask your plumber or installer to check your three measurements against the fitting range on the product page.
  2. Download the Shower Door Confirmation form below and fill it in.
  3. After you order, email the completed form with your order number to orders@pjmatthews.ie so we can double-check it before your door is dispatched.

Downloads

Not sure which size you need? Give us a call on +353 61 413722 or call into our shop on Tipperary Road, Limerick, and we'll help you check.